Installation

Our panel mount system makes the installation quick and easy.

Step 1: Pull a string line from property corner to property corner where fence will be installed.

Step 2: Order the post a minimum of 2’ longer than the panel height. (4’ panel needs minimum 6’ post)

Step 3 directions is based upon level terrain. If terrain is sloped additional post will need to be installed closer together to avoid large gaps under fence.

Step 3: Set post 94-1/2” face of post to face of post) along the string line. Post hole needs to be a minimum of 4” and we suggest 6” in diameter. When post are set in concrete, make sure you leave the panel height + 3” above ground level. This will allow you to leave 2” under the panel and 1” for the installation of the post cap. (Very Important-***Make sure post are level upon installation).

Step 4: After post concrete is dry, Install panel mount brackets(4 per panel) into the ends of the rail on the panel.

Step 5: Place panel between post and make sure panels is level.

Step 6: Use self tapping tek screw to mount the panel mount brackets to the post.

Step 7: Install caps on post

Step 1: Pull a string line from property corner to property corner where fence will be installed.

Step 2: Order the post a minimum of 2’ longer than the panel height. (4’ panel needs minimum 6’ post)

*Step 3 directions is based upon level terrain. If terrain is sloped additional post will need to be installed closer together to avoid large gaps under fence.

Step 3: Set post 94” face of post to face of post) along the string line. Post hole needs to be a minimum of 4” and we suggest 6” in diameter. When post are set in concrete, make sure you leave the panel height + 3” above ground level. This will allow you to leave 2” under the panel and 1” for the installation of the post cap. (Very important-Make sure post are level upon installation.)

Step 4: Place panel between post and make sure panels is level.

Step 6: Weld panel to post . Very Important***Clean, prime and paint weld spots to avoid Rusting

Step 7: Install caps on post